Re: Incorrect timings in Grinder..!!

On 5 Feb 2015 09:07, "shatakirti" <[email protected]> wrote:
>
> Here's an issue that i am facing. I made a simple call to an API using
> grinder.
> The setup - *Single agent, single thread, single API, 100 runs.*
>
> So, from grinder, i found that each request took about *2.5 seconds*. for
a
> 200 OK request.
> Then i tried the same API through browser, and every time i made this
> request, it didn't take more than *1.2 seconds* for a 200 OK request (each
> time cache was cleared).

It is not clear how you can make 100 consecutive requests through a
browser, including clearing the cache, and do so as fast as The Grinder
would - assuming you are not using long Grinder sleep times.

Try looping using curl (Linux or Cygwin) or similar to request 100 times to
see if the average of the 100 response times reported by curl is comparable
to The Grinder.

Gary

------------------------------------------------------------------------------
Dive into the World of Parallel Programming. The Go Parallel Website,
sponsored by Intel and developed in partnership with Slashdot Media, is your
hub for all things parallel software development, from weekly thought
leadership blogs to news, videos, case studies, tutorials and more. Take a
look and join the conversation now. http://goparallel.sourceforge.net/

_______________________________________________
grinder-use mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/grinder-use