Re: [jgroups-users] using jgroups with multiple NICs

Ugh, really bad formatting happened in this question. Trying again:

On Wed, Nov 14, 2018 at 3:11 PM Questions/problems related to using JGroups
<[email protected]> wrote:

> Our product uses a TCP based stack, jgroups 4.0.13.Final. A customer has
> asked [sic below]:
>
> "how to tell the <my product> that "use both (or all) interfaces for <my
> product>-messaging"? We noticed that jgroups have this possibility. "
>





> I don't see how jgroups can use >1 bind address, i.e. because you can't
> send a tcp heartbeat request from more than one address (that would be >1
> request).
>
> I *think* they want jgroups to monitor two separate networks (each node
> has 2 addresses, one for production and one for monitoring). If one network
> goes down then our product still sees that the other is running. We would
> need two separate channels for that, right?
>
> I know this all sounds simple, but am trying to wrap my head around what
> it is the customer wants. If I could share their slides that might help --
> I think this is a 2 minute question except that I'm taking 10 minutes
> trying to explain it....
>
>

_______________________________________________
javagroups-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/javagroups-users