Re: [JXTA discuss] How do I manually start a resolver service

Without a ResolverService, services such as Discovery, Pipe, Router, 
etc., which rely on it would not be operational, regardless of the mode 
the peer is running (adhoc, edge, or rendezvous).

Hope that helps,
Mohamed

Daniel Brookshier wrote:

> But the question is, is the Resolver active when you are not a RDV? 
> The experiments seem to point to it working only between RDV.
>
> On Mar 30, 2005, at 5:04 PM, Mohamed Abdelaziz wrote:
>
>> If your service relies on other services to be available, then it 
>> should return START_AGAIN_STALLED to indicate to the group that it 
>> should be called again, it should return START_AGAIN_STALLED until 
>> the required services have started, after which it should return 
>> START_OK.  The service should also postpone any calls to the required 
>> service until such services have started.
>>
>> Also the ResolverService has always been part the JXTA group spec 
>> definition (1.0 through 2.x), and have always been started unless 
>> explicitly removed from a group definition.
>>
>> Mohamed
>>
>>
>>
>>    public int startApp(String[] arg) {
>>        resolver = group.getResolverService();
>>
>>        if (null == resolver) {
>>            if (LOG.isEnabledFor(Level.WARN)) {
>>                LOG.warn("Stalled until the resolver service");
>>            }
>>            return Module.START_AGAIN_STALLED;
>>        }
>>
>>
>>
>> [email protected] wrote:
>>
>>> Hi,
>>>  I have created a JXTA service and added it to a new peergroup and 
>>> started that peergroup. Then, I successfully lookupService(new 
>>> service). The purpose of the new services is to pass messages 
>>> between two peers.  However, message are lost. I guess that the 
>>> resolver services is not started on the new peergroup that I 
>>> created. see message.
>>>  <WARN  2005-03-30 15:49:21,152 
>>> DiscoveryServiceImpl::getRemoteAdvertisements:291> resolver has not 
>>> started yet, query discarded.
>>>  <WARN  2005-03-30 15:58:40,788 
>>> ResolverServiceImpl::processSrdi:1051> No srdi handler registered 
>>> :urn:jxta:uuid-DEADBEEFDEAFBABAFEEDBABE0000000305
>>>  But, I don't know how to manually started the ResolverService on a 
>>> new peergroup. Or, that may not be the problem. Does anyone have 
>>> good ideas or explainations for it.
>>>  Thanks,
>>>  -Ray
>>>
>>
>>
>>
>> ---------------------------------------------------------------------
>> To unsubscribe, e-mail: [email protected]
>> For additional commands, e-mail: [email protected]
>>
>>
>
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: [email protected]
> For additional commands, e-mail: [email protected]
>