Re: Joining group as Rendezvous

The "UP" and "DOWN" indications are a network graph
distinction.  There is a really good description of how it works
in the following document:

http://www.jxta.org/docs/jxta-dht.pdf

I just recently read it myself! ;)

Mike

On 7/28/05, Joerg Beyersdorf <[email protected]> wrote:
> Thanks Mike & Mohamed,
> 
> Mohamed Abdelaziz wrote:
> > The join command defaults to edge, you must specify "-r" to join a group as a
> > rendezvous.  Also here's are a few hints : - use rdv  (switches mode to rdv,
> > -edge to edge, -rpv to list the peer view)
> 
> Could someone explain me the prompt after typing 'rdvstatus' in the shell
> (running as edge peer)? As far as I understand, in section "Peer View:" I see
> all known rdvs and I think the "up" and "down" attributes map the information
> cycle of the peer view exchange (but from which perspective? as edge peer I
> shouldn't be involved in the exchange of peer views between the rdvs).
> 
> But I'm always "connected" to only _one_ rdv ("Rendezvous Connections:"). Can I
> change the one rdv I'm "connected" to? When I use "rdv -connect" nothing changes
> because the shell responses "Already connected".
> 
> thx, J.
> 
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: [email protected]
> For additional commands, e-mail: [email protected]
> 
> 


-- 
Mike Cumings