Re: Output and JSTL

Hi Shash,

Thanks for looking at this. It does work. I must have been having finger 
problems last time I tried. As you say the "model" prefix is not 
required and <c:out value="${myoutput.map['content']}" default=""/> 
works. I will now try nested outputs.

Thanks again,
Max

> Max,
>
>>
>> *Problem1:*
>>
>> However I am having difficulty in accessing the outputs by name. From 
>> the OutputsInMaverickJSTL Wiki it says that named outputs can be 
>> accessed using something like:
>>
>>    <c:out value="${model.myoutput.map['content']}" default=""/>
>>
>> This does not work and neither does:
>>
>>    <c:out value="${myoutput.map['content']}" default=""/>
>>
>> I looked at the code in StrutsClientConnector where I think the 
>> response elements are added to the DynaBean, but I cannot see where 
>> the elements are added by name. Also as they are added as an array 
>> and not as a Map so the elements cannot be referenced using something 
>> like outputs['myoutput']. I seem to remember doing this in Expresso.
>>
> I finally got a chance to look at this, using the Maverick client.  
> The doc was wrong....for "named" outputs, just skip the "model." 
> prefix....i.e., use: <c:out value="${myoutput.map['content']}" 
> default=""/>.  In StrutsClientConnector, line 179, it is also added to 
> the webapp-request, I guess you'd have to get the output as an 
> attribute from the request first....I haven't tried it, though.
>
> Shash


http://keelframework.org/documentation.shtml
Keelgroup mailing list
[email protected]
http://lists.keelframework.com/listinfo.cgi/keelgroup-keelframework.com