Re: How to remove a node from a project's logical view?

Instead of showing/hiding the node, would it be acceptable if its 
display name was "Not Configured" if the checkbox has not been selected? 
That would have as a benefit that the user would have a hint that the 
functionality exists and that it needs to be configured.

If the above is acceptable to you, I have all the code for this solution.

Gj

On 21-1-2016 12:19, Peter Nabbefeld wrote:
> Hm, not yet - I'll try to put some files at the week-end.
>
> What I want to do is sth. like this:
> 1. Project cutomizer:
> +------------------+-----------------------------+
> | 1. Sources       |                             |
> | 2. *My Options*  |                             |
> | 3. ...           |     [x] Show my node        |
> |                  |                             |
> |                  |                             |
> +------------------+-----------------------------+
>
> 2. Project tab:
> +-------------------------+
> |   # My Project          |
> |   |                     |
> |   +--# My Node          |
> |   |                     |
> |   +--# Source Packages  |
> |   |                     |
> |   +--# Libraries        |
> |                         |
> +-------------------------+
>
> The Node "My Node" should only be shown, if the checkbox is set.
>
> The tricky part here is, that the node should be updated immediately after
> configuration change, so I think I will have to get the tab and to repaint
> the project tree.
>
> Kind regards
> Peter
>