Re: How to remove a node from a project's logical view?

Hi Geertjan,

thank You for providing the code!

Using Arch Linux, there seem to be problems with the installed NetBeans 
package when starting a mavenized module project, so I just copied the 
sources into my ant project.

The sources work, and from my point of view there're two main mechanisms 
to provide the magic:

1. I've never been *really* aware, that NodeFactory provides a NodeList, 
which may or may not contain nodes.

2. The NodeList holds a reference to the project references and adds 
itself as a PreferenceChangeListener.

The latter, however, makes it impossible to use AuxilliaryConfiguration.
As I'd  prefer to use the XML hierarchy of project.xml: Is there any way 
to add some change listener to it?

Kind regards
Peter



Am 21.01.2016 um 20:30 schrieb geertjan wielenga:
>
>
> Yes, that's precisely what the code provides. Check it out and take a look:
>
> https://github.com/GeertjanWielenga/PeterProjectCustomizerNodeFactory
>
> Gj
>
> On 21-1-2016 18:55, Peter Nabbefeld wrote:
>> Hi Geertjan,
>>
>> thank You for Your support! But the point is: The configuration should
>> be "defensive", i.e. nothing should be changed, neither in project.xml
>> nor in project ui, if there's no configuration.
>>
>> Kind regards
>> Peter
>>
>>
>>
>> Am 21.01.2016 um 15:45 schrieb geertjan wielenga:
>>>
>>> Instead of showing/hiding the node, would it be acceptable if its
>>> display name was "Not Configured" if the checkbox has not been selected?
>>> That would have as a benefit that the user would have a hint that the
>>> functionality exists and that it needs to be configured.
>>>
>>> If the above is acceptable to you, I have all the code for this
>>> solution.
>>>
>>> Gj
>>>
>>> On 21-1-2016 12:19, Peter Nabbefeld wrote:
>>>> Hm, not yet - I'll try to put some files at the week-end.
>>>>
>>>> What I want to do is sth. like this:
>>>> 1. Project cutomizer:
>>>> +------------------+-----------------------------+
>>>> | 1. Sources       |                             |
>>>> | 2. *My Options*  |                             |
>>>> | 3. ...           |     [x] Show my node        |
>>>> |                  |                             |
>>>> |                  |                             |
>>>> +------------------+-----------------------------+
>>>>
>>>> 2. Project tab:
>>>> +-------------------------+
>>>> |   # My Project          |
>>>> |   |                     |
>>>> |   +--# My Node          |
>>>> |   |                     |
>>>> |   +--# Source Packages  |
>>>> |   |                     |
>>>> |   +--# Libraries        |
>>>> |                         |
>>>> +-------------------------+
>>>>
>>>> The Node "My Node" should only be shown, if the checkbox is set.
>>>>
>>>> The tricky part here is, that the node should be updated immediately
>>>> after
>>>> configuration change, so I think I will have to get the tab and to
>>>> repaint
>>>> the project tree.
>>>>
>>>> Kind regards
>>>> Peter
>>>>
>>>
>>>
>>
>
>