RE: RE: NTLM authentication issues with Internet Explorer

Jeremy,

We'll probably have to keep NTLM turned off as well.  I was told there's
a Scarab development email group, I'm going to send this issue to them
to see if they know about this and if there is a solution, or maybe they
can put it on the list to fix.  I'll let you know what I find out.

Thanks,
gs 

-----Original Message-----
From: Gaither, Jeremy [mailto:[email protected]] 
Sent: Wednesday, November 07, 2007 7:47 PM
To: [email protected]
Subject: RE: NTLM authentication issues with Internet Explorer

I've seen similar issues.  I was running Scarab under Tomcat 5.0 with
Windows Server 2003, so I doubt this has anything to do with linux.

Rarely, I've seen this issue (or similar issues) with IE6 and IE7
without NTLM authentication enabled.  I haven't figured out how to
reproduce the issue.  Scarab will usually throw me back to a login
prompt, and refuse to continue from there.  Typically, closing all
instances of IE resolves the issue.

http://www.nabble.com/Issues-cannot-be-saved-when-working-with-IE-t35041
29.html#a9828002

I was eventually forced to turn Windows authentication off.

_______________
Jeremy Gaither 


-----Original Message-----
From: Sieroslawski, Glen [mailto:[email protected]]
Sent: Wednesday, November 07, 2007 10:50 AM
To: [email protected]
Subject: NTLM authentication issues with Internet Explorer

I am trying to set up Scarab .21 to use NTLM authentication on RedHat 5
following the setup instructions found in at
http://www.solitone.org/scarab-trunk-doc/howto/windowsdomain-howto.html 

After I got NTLM running I was able to use it to login to Scarab using
the browser Internet Explorer.  However, I encountered a problems when
trying to enter an new issue or performing an advanced search.  When
trying to enter an issue I would complete all the attribute fields and
press the "done" button which would refresh the screen and then all the
attribute fields were empty and the issue was not entered.  The same
thing happens when searching for an issue, the returned results are
empty.  

Next I tried to enter and search for issues using Firefox and it worked
just fine.  Issues were created and searches returned results.  

I then turned NTLM off and was able to enter and search for issues using
IE.    

My question is if anyone has seen the same behavior and is there a way
to fix it?

Glen Sieroslawski
Sr. Software Configuration Manager
 
Intrado Inc.
1601 Dry Creek Drive
Longmont, CO 80503
direct:  720-864-5088
email:  [email protected]

---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]

---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]