Re: question about debugging QT AT-SPI support

Hi Mike,

On Tuesday, September 23, 2014 12:13:26 AM Mike Gorse wrote:
> Hi,
> 
> I'm trying to run yast, the configuration tool used by SUSE. When I use
> the qt5 back end, I get accessibility via AT-SPI when it is run as my
> normal user but not when run as root. I'm trying to figure out why the
> bridge doesn't seem to work / be enabled when running as root. One of my
> problems was that DBUS_SESSION_BUS_ADDRESS was not being set in my
> session, but it still does not work even after I check that it is set. Is
> there a good way to debug it / a good place to start? I tried adding lines
> into dbusconnection.cpp to write text to qDebug(), hoping that it would
> result in my seeing the text on stdout or stderr, but it seems to have no
> effect even if I don't run yast as root and the bridge is working
> normally. Perhaps there's some initialization that I need to do--I'm
> really not familiar with the code. :(

I think it's most likely because the Qt bridge uses the session bus to get the 
a11y bus address. I used this way of implementing it because with for example 
Wayland the other way - using XAtoms will not be an option.

I suppose changing the code to prefer the XAtom way of getting the a11y bus 
should make this work.

The code in question is in 
qtbase/src/platformsupport/linuxaccessibility/dbusconnection.cpp

I will not be able to work on this for the next two weeks (I'll be mostly 
offline), so if anyone wants to try changing/implementing this, feel free to do 
so.

Cheers,
Frederik




> 
> THanks,
> -Mike
> _______________________________________________
> kde-accessibility mailing list
> [email protected]
> https://mail.kde.org/mailman/listinfo/kde-accessibility