Re: Cyrus didn't answer on port 993, SSL missing_

Am Samstag, 11. Mai 2013, 18:51:03 schrieb Jeroen van Meeuwen:
> On 2013-05-11 13:32, Richard wrote:
> > Hi Ruediger,
> > 
> > Op zaterdag 11 mei 2013 13:52:38 schreef Ruediger Goetz:
> >> Hello
> >> 
> >> Thanks for your help. I followed
> >> http://docs.kolab.org/de-DE/Kolab_Groupware/3.0/html-single/Community_Insta
> >> llation_Guide/index.html where nothing about kolab-prep-setup is 
> >> found.
> > 
> > That is because Community_Installation_Guide is a general guide.  
> > kolab-prep-
> > setup is especially created to support kolab on openSUSE.  It makes 
> > changes
> > openSUSE related, that are needed before Kolab is installed on 
> > openSUSE.
> > 
> 
> Is anyone interested in making the upstream setup-kolab be able to make 
> such platform specific changes, for as far as they are platform specific 
> (generating a CA / self-signed cert is not platform specific), if not 
> simply integrating in to upstream documentation, the recommended 
> additional steps that need to be taken for the use of openSUSE as a 
> platform?
> 
> Kind regards,
> 
> Jeroen van Meeuwen
> 
> 

That would be my part - I'll try to integrate as much of these into setup-kolab this summer.

-- 
Aeneas Jaissle (ITS) e: [email protected] w: www.sewinet.de
SeWiKom GmbH, Lange Str. 20, 37688 Beverungen, Germany
GF: Kai-Timo Wilke, HRB 8516 (AG Paderborn), BNetzA 09/118