error in executing qvfb

  Hi All,

when i run the ./qvfb its displaying as "using display 0" and nothing comes up?

qvfb in qt-x11-free-3.3.8, does not support the "depth 16",
qvfb supports depth 1,4,8,32 only.

but if i see in /etc/x11/XF86Config-4 file,

it shows like "default depth 16"
section "screen"
  driver "ATI MAC64"
  default depth "16"
subsection "monitor"
  depth 16
  mode  1024 X 768
endsection

Is this really causing the problem in showing up the window? any solution to this?

regards
Pavan Reddy.
Note: Forwarded message attached

-- Original Message --

From: "Pavan Kumar Reddy" <[email protected]>
To: "saravanan sar" <[email protected]>
Cc: For discussion of Konqueror/Embedded <[email protected]>
Subject: Re: Re: Re: error in executing konqueror

_______________________________________________
konq-e mailing list
[email protected]
https://mail.kde.org/mailman/listinfo/konq-e