Re: KonquerorE cross compile for ARM

>
> Akshay: Your suggestions are similar. I need to find
> install this zlib package, but being that this
> compiler was given to me as is, I will have to ether
> get a newer one with full developer support or find
> this zlib. Do you know where I can get this?
>
> Once again thank you for valuable suggestions.

Without reading your full mail, I provide what I used and what worked
for me here:

For the toolchain I use the ltib (bitshrine/freescale).

I used the following config:
./configure --enable-static --enable-embedded --enable-qpe
--enable-qt-embedded --host=arm-linux
--with-qt-dir=/home/akshay/builddir/rpm/BUILD/qtopia-free-2.2.0/qtopia/qt2/
--with-qtopia-dir=/home/akshay/builddir/rpm/BUILD/qtopia-free-2.2.0/qtopia
--with-qtopia-includes=/home/akshay/builddir/rpm/BUILD/qtopia-free-2.2.0/qtopia/include
--with-qt-includes=/home/akshay/builddir/rpm/BUILD/qtopia-free-2.2.0/qt2/include
--with-qt-libraries=/home/akshay/builddir/rpm/BUILD/qtopia-free-2.2.0/qtopia/lib
--with-extra-libs=/arm/lib --with-extra-includes=/arm/include
--with-ssl-dir=/home/akshay/builddir/rpm/BUILD/openssl-0.9.7m

I put all the zlib etc in /arm/lib and includes in /arm/include.

for zlib I used the zlib-1.1.4. zlib should be present in your
enviroment someplace. find them. Else zlib.net might be a useful site.
Do not use the x86 files for cross compile. they'll fail, if not in
configure than in make later. missing zlib.h is not a fault of
gcc-2.95.

hth,
Akshay