Re: configure probs on RH7.3

The config.log file "appears" to be clean.  The last several lines are a series of
#define statements, followed by "exit 0".  However... I still have the
"missing..." message and a notification that kpovmodeler will _not_ be compiled.

Ken

CARVALHO Luis Passos wrote:

> Check the last few lines of config.log. Probably it will mention which
> include files or libraries you are missing.
>
> Then it's just a matter of finding the correct rpm needed to install those
> missing files.
>
> Regards,
> Luis
>
> > -----Original Message-----
> > From: Ken Ramey [mailto:[email protected]]
> > Sent: quarta-feira, 31 de Julho de 2002 17:00
> > To: [email protected]
> > Subject: configure probs on RH7.3
> >
> >
> > I have been trying to install kpm on a new RH7.3 system installed on a
> > laptop.  Even though I have downloaded Mesa and installed it, the
> > configure script keeps saying I am missing "at least one of
> > opengl(mesa),  glu, glut, glx".  It then directs me to www.mesa.org
> > (should be mesa3d) to get the missing component(s).
> >
> > Any suggestions?
> >
> > Thanks.
> >
> > Ken Ramey
> >
> >
> > List archive and information:
> > http://mail.kde.org/mailman/listinfo/kpovmodeler-devel
> >
>
> List archive and information: http://mail.kde.org/mailman/listinfo/kpovmodeler-devel


List archive and information: http://mail.kde.org/mailman/listinfo/kpovmodeler-devel