clamav at fresh installation

Hi everybody.

Can someone help with clamav problem please? Thank you very much.

Greetings ladas


During "kolab-settings" configuration I got this message:

Kolab Service password [******************]: 
ERROR: Can't open /var/log/clamav/freshclam.log in append mode (check
permissions!).
ERROR: Problem with internal logger (UpdateLogFile =
/var/log/clamav/freshclam.log).
Job for [email protected] failed because start of the service was
attempted too often. See "systemctl status [email protected]" and
"journalctl -xe" for details.
To force a start use "systemctl reset-failed [email protected]"
followed by "systemctl start [email protected]" again.
Created symlink from /etc/systemd/system/multi-
user.target.wants/amavisd.service to
/usr/lib/systemd/system/amavisd.service.

And when I force to start and check clamav daemon does not work:

systemctl status [email protected]
● [email protected] - clamd scanner (amavisd) daemon
   Loaded: loaded (/etc/systemd/system/[email protected]; enabled; vendor
preset: disabled)
   Active: failed (Result: start-limit) since Po 2019-02-18 17:25:36
CET; 10s ago
     Docs: man:clamd(8)
           man:clamd.conf(5)
           https://www.clamav.net/documents/
  Process: 3826 ExecStart=/usr/sbin/clamd -c /etc/clamd.d/%i.conf
(code=exited, status=1/FAILURE)

úno 18 17:25:36 kolab.mydomain.local  systemd[1]: [email protected]
: control process exited, code=exited...us=1
úno 18 17:25:36  kolab.mydomain.local systemd[1]: Failed to start clamd
scanner (amavisd) daemon.
úno 18 17:25:36  kolab.mydomain.local systemd[1]: Unit [email protected]
rvice entered failed state.
úno 18 17:25:36  kolab.mydomain.local systemd[1]: [email protected]
 failed.
úno 18 17:25:36  kolab.mydomain.local systemd[1]: [email protected]
 holdoff time over, scheduling restart.
úno 18 17:25:36  kolab.mydomain.local systemd[1]: Stopped clamd scanner
(amavisd) daemon.
úno 18 17:25:36  kolab.mydomain.local systemd[1]: start request
repeated too quickly for [email protected]
úno 18 17:25:36  kolab.mydomain.local systemd[1]: Failed to start clamd
scanner (amavisd) daemon.
úno 18 17:25:36  kolab.mydomain.local systemd[1]: Unit [email protected]
rvice entered failed state.
úno 18 17:25:36  kolab.mydomain.local systemd[1]: [email protected]
 failed.
Hint: Some lines were ellipsized, use -l to show in full.

_______________________________________________
users mailing list
[email protected]
https://lists.kolab.org/mailman/listinfo/users