Re: clamav at fresh installation

What distribution is this on?  Is this a new install or an update?

On 2019-02-18 11:31, L.Slanina wrote:
> Hi everybody.
> 
> Can someone help with clamav problem please? Thank you very much.
> 
> Greetings ladas
> 
> During "kolab-settings" configuration I got this message:
> 
> Kolab Service password [******************]:
> ERROR: Can't open /var/log/clamav/freshclam.log in append mode (check
> permissions!).
> ERROR: Problem with internal logger (UpdateLogFile =
> /var/log/clamav/freshclam.log).
> Job for [email protected] failed because start of the service was
> attempted too often. See "systemctl status [email protected]" and
> "journalctl -xe" for details.
> To force a start use "systemctl reset-failed [email protected]"
> followed by "systemctl start [email protected]" again.
> Created symlink from
> /etc/systemd/system/multi-user.target.wants/amavisd.service to
> /usr/lib/systemd/system/amavisd.service.
> 
> And when I force to start and check clamav daemon does not work:
> 
> systemctl status [email protected]
> ● [email protected] - clamd scanner (amavisd) daemon
>    Loaded: loaded (/etc/systemd/system/[email protected]; enabled; vendor
> preset: disabled)
>    Active: failed (Result: start-limit) since Po 2019-02-18 17:25:36
> CET; 10s ago
>      Docs: man:clamd(8)
>            man:clamd.conf(5)
>            https://www.clamav.net/documents/
>   Process: 3826 ExecStart=/usr/sbin/clamd -c /etc/clamd.d/%i.conf
> (code=exited, status=1/FAILURE)
> 
> úno 18 17:25:36 kolab.mydomain.local  systemd[1]:
> [email protected]: control process exited, code=exited...us=1
> úno 18 17:25:36  kolab.mydomain.local systemd[1]: Failed to start
> clamd scanner (amavisd) daemon.
> úno 18 17:25:36  kolab.mydomain.local systemd[1]: Unit
> [email protected] entered failed state.
> úno 18 17:25:36  kolab.mydomain.local systemd[1]:
> [email protected] failed.
> úno 18 17:25:36  kolab.mydomain.local systemd[1]:
> [email protected] holdoff time over, scheduling restart.
> úno 18 17:25:36  kolab.mydomain.local systemd[1]: Stopped clamd
> scanner (amavisd) daemon.
> úno 18 17:25:36  kolab.mydomain.local systemd[1]: start request
> repeated too quickly for [email protected]
> úno 18 17:25:36  kolab.mydomain.local systemd[1]: Failed to start
> clamd scanner (amavisd) daemon.
> úno 18 17:25:36  kolab.mydomain.local systemd[1]: Unit
> [email protected] entered failed state.
> úno 18 17:25:36  kolab.mydomain.local systemd[1]:
> [email protected] failed.
> Hint: Some lines were ellipsized, use -l to show in full.
> _______________________________________________
> users mailing list
> [email protected]
> https://lists.kolab.org/mailman/listinfo/users
_______________________________________________
users mailing list
[email protected]
https://lists.kolab.org/mailman/listinfo/users