Re: pqt-designer for Debian - Segmentation fault

I'm sorry but there does not seem to be an official .deb-package for the 
perleditor plugin. I quickly searched the package list with no results.

Perhaps someone has an build a .deb-package of his own?

Oliver

David Greaves wrote:
> Oliver Kreuer wrote:
> 
>> Hello David,
>>
>> there is a qt-designer package for Debian. It's called "qt3-designer".
>> I've installed the following .deb-packages via apt-get:
>>
> <snip - ta>
> 
>> All works fine. The designer is started by simply entering "designer" 
>> in a shell.
>>
>> Regards,
>> Oliver
>>
> Thanks Oliver
> 
> I have those - essentially I'm after the perleditor plugin that lets me 
> select a Perl project, much like a C++ project.
> Have you seen it?
>  http://perlqt.sourceforge.net/designer.png
> or
>  
> http://perlqt.sourceforge.net/dist/current/doc/en/index.html#rad_prototyping_with_qt_designer_and_puic 
> 
> 
> I 'apt-get source' downloaded, patched and compiled qt (didn't install 
> it) and can run the resulting pqt-designer but it segfaults on me :(
> 
> Apparently, due to some minor (4 lines of code minor) problems in the 
> distributed qt-designer the plugin needs a custom build of qt-designer...
> (hmm, sidetrack... thinks... I just tried the plugin in the standard 
> 3.3.2 designer and it loads and works to a point - but I get the same 
> segfault)
> 
> David
> _______________________________________________
> Kde-perl mailing list
> [email protected]
> https://mail.kde.org/mailman/listinfo/kde-perl