RE: Nvidia 2070 Super supported for OpenCL?

"bryan-DBL96jL5/Q/[email protected]" <bryan-DBL96jL5/Q/[email protected]>
Newsgroups gmane.comp.kde.digikam.user
Message-ID <CH3PR19MB78545A40AB4FDB4E6744396CA7FFA@CH3PR19MB7854.namprd19.prod.outlook.com> 
Apologies for replying to myself, I realized I sent the last message without important version/troubleshooting information:

Platform: Windows 10 Pro, 10.0.19045 Build 19045
DigiKam version 8.8.0

In DigiKam, Help > Components Information states that OpenCL Availability is "No"

I noticed that the ToolTip when enabling OpenCL states, "This option is still experimental and requires that certain environment variables are set manually." I checked the docs but could not find a reference to these environment variables. I found this note online (https://discuss.pixls.us/t/opencl-not-showing-in-digikam/49711/4) suggesting that adding "OPENCV_OPENCL_DEVICE=NVIDIA:GPU:" might correct the issue.

I added a system-wide environment variable (via Control Panel > System Properties > Environment Variables > System Variables) of "OPENCV_OPENCL_DEVICE" ="NVIDIA:GPU:" , validated it was set in the command line, then restarted DigiKam. Still no change.

Any further troubleshooting I should perform?
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.