Automatically starting a slideshow
"Chris Larkee" <ChrisL-w2lBaiJYZrO+fUK6pPxwr1aTQe2KTcn/@public.gmane.org>
| Newsgroups | gmane.comp.kde.gwenview |
|---|---|
| Message-ID | <[email protected]> |
Hello. I noticed this old thread here where someone asked if was possible to launch gwenview in slideshow mode from the command line, so that someone could launch it without human interaction: http://www.nabble.com/Digital-picture-frame-with-Gwenview-t4253944.html I'm looking for a similar solution, so has anything new developed? I tried looking in DCOP, but I didn't see anything there. Would trying out gwenview 2 offer anything towards this? I'd use an alternate slideshow program only if they also supported video like gwenview does. -Chris Larkee ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Gwenview-general mailing list Gwenview-general-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f@public.gmane.org https://lists.sourceforge.net/lists/listinfo/gwenview-general