Re: Problem with K3b and dual layer DVDs

On Friday 09 July 2010 10:39:06 am Srdjan Todorovic wrote:
> Hi,
> 
> On 9 July 2010 15:28, E. Hakan Duran <[email protected]> wrote:
> > On Thursday 08 July 2010 19:53:06 Chris Smart wrote:
> >> On Fri, Jul 9, 2010 at 9:09 AM, Praedor Atrebates <[email protected]> wrote:
> >> > I have been trying to burn a dvd iso to dual layer DVD+R disks and so far
> >> > K3b has turned two of them into coasters.  I get about 50% complete and
> >> > then there's an error (input/output error).  I cannot afford to keep
> >> > turning perfectly fine blank DVD+R DL disks into coasters and would
> >> > greatly appreciate some help on getting K3b to burn to them properly.
> >
> > Same experience here, couldn't find any solution.
> 
> Have you tried to run the individual commands that K3B runs, but via the shell?
> 
> That way, you may be able to determine if this is a K3b logic bug, or
> a hardware support / disk I/O bug.
[...]

I can try that and brasero after I buy more DL dvds but that will be a bit.

-- 
"The modern conservative is engaged in one of man's oldest exercises in moral
philosophy; that is, the search for a superior moral justification for
selfishness." 
-- John Kenneth Galbraith

------------------------------------------------------------------------------
This SF.net email is sponsored by Sprint
What will you do first with EVO, the first 4G phone?
Visit sprint.com/first -- http://p.sf.net/sfu/sprint-com-first