Re: Problems with cx88xx

Ok, I copied the file in the source dir, removed the two slashes and
compiled (with debug enabled). kdetv did not work much better, still
hangs at the same point (after selecting the device)
Attached is the new strace (hope it helps).
BTW: I'm running 0.8.2 (not sure if this matters but I forgot to tell
that, iirc)

Am Donnerstag, den 16.09.2004, 20:49 +0200 schrieb Dirk Ziegelmeier:
> On Thursday 16 September 2004 20:26, Dirk Ziegelmeier wrote:
> > On Wednesday 15 September 2004 23:26, Christoph Brill wrote:
> > > Find attached the complete strace in bzip2ed textfile. It was generated
> > > with the command "strace kdetv 2> strace-kdetv-2004-09-15". When kdetv
> > > hang, I pressed CTRL+C
> >
> > OK, please try it with the attached file (kvideoio/v4ldev.cpp) and tell me
> > if it works. If not, send me a "strace" again.
> Ooops, one call too much eliminated:
> 
> in kvideoio/v4ldev.cpp: QSize V4LDev::grab(unsigned char* img)
> 
> //        syncCurrentFrame();
> 
> remove the comment chars.
> 
> Sorry,
> Dirk
>

_______________________________________________
kwintv mailing list
[email protected]
https://mail.kde.org/mailman/listinfo/kwintv