Re: Re: remote control support

Hi,
Unfortunatley, I can't read this :-(

Here's where I'm at. There seems to be little to no documentation on
this topic. I'd be willing to write it if I can get this working.

The remote control is working. Using the lircrc for TV-Time, I can
control tv-time almost perfectly. So, I understand the lircd part of
the equation. What I don't understand is the KDE part of the equation.
How do I get lircd talking to irkick? It seems to me that I would need
some form of communication between the two? 

The irkick web-site has been down for a while now:
webcvs.kde.org/kdeutils/kdelirc/?sortdir=down

Thanks again for all your help! It's much appriciated.
Jeremy



On Wed, 13 Apr 2005 11:03:31 +0200, "farkas miklos"
<[email protected]> wrote :

> Kedves Zsolt!
> 
> Sajnálattal közlöm hogy az angol nyelvtudásom messz áll attól
hogy az alábbi 
> szöveget megértsem.
> Gondom van (volt) a Linux alatti  Tv -tuner müködésével és
lehet hogy azért 
> töltöttem ki  a forum -lapot.
> köszönettel : farkas miklos
> 
> 
> ----- Original Message ----- 
> From: "Zsolt Rizsanyi" <[email protected]>
> To: "KWinTV General Mailing List" <[email protected]>
> Sent: Tuesday, April 12, 2005 10:35 PM
> Subject: Re: [Kwintv] remote control support
> 
> 
> > [email protected] wrote:
> >> I guess I don't understand. I have the remote communicating with my
> >> box. If
> >>  I
> >> run irw, I can see the output. I have irkick running, but there's
> >> nothing to
> >> configure. There's nothing listed in the controller functions box
and my
> >> remote doesn't show up as a loaded extension. I've search
everywhere and
> >> cannot find a kdelirc program, config file, or anything. I have
kde-base
> >> installed.
> >
> > irkick is part of kdelirc suite (there is the config dialog too,
which is 
> > a
> > separate program) so I was talking about that.
> > If you don't have anything to configure in the kdelirc
configuration that
> > means, that your remote is not supported with it.
> > You could easily write a new remote definition file for kdelirc
based on
> > one existing one in /usr/share/apps/remotes/.
> > If you have kernel 2.6 and you are using the linux-input-layer
with lirc,
> > then I can send you my remote config file for that.
> > If you encounter any problems then you could contact the kdelirc 
> > maintainer
> > for help (he may be able to create the definition file based on your
> > lircd.conf).
> >
> > Regards,
> > Zsolt
> > _______________________________________________
> > kwintv mailing list
> > [email protected]
> > https://mail.kde.org/mailman/listinfo/kwintv
> >
> > __________ NOD32 1.1059 (20050412) Information __________
> >
> > This message was checked by NOD32 antivirus system.
> > http://www.nod32.com
> >
> > 
> 
> _______________________________________________
> kwintv mailing list
> [email protected]
> https://mail.kde.org/mailman/listinfo/kwintv
> 
> 
> 

-- 
Registered Linux User #346571