Re: kdetv doesnt recognize my card

birbilis schrieb:

>i'm terribly sorry...
>my card is prolink pixelview playtv pro based on the bt878 chip. 
>my lsmod gives me::
>
>bash-2.05b# lsmod
>Module                  Size  Used by
>smbfs                  64632  0
>snd_pcm_oss            50208  0
>snd_mixer_oss          19072  1 snd_pcm_oss
>tuner                  22564  0
>bttv                  150224  0
>video_buf              18564  1 bttv
>firmware_class          8960  1 bttv
>i2c_algo_bit            9992  1 bttv
>v4l2_common             5760  1 bttv
>btcx_risc               5000  1 bttv
>tveeprom               12696  1 bttv
>i2c_core               19968  4 tuner,bttv,i2c_algo_bit,tveeprom
>videodev                8704  1 bttv
>snd_cmipci             29440  0
>snd_pcm                85124  2 snd_pcm_oss,snd_cmipci
>snd_page_alloc          8708  1 snd_pcm
>snd_opl3_lib           10240  1 snd_cmipci
>snd_timer              22788  2 snd_pcm,snd_opl3_lib
>snd_hwdep               8608  1 snd_opl3_lib
>snd_mpu401_uart         7552  1 snd_cmipci
>snd_rawmidi            21536  1 snd_mpu401_uart
>snd_seq_device          7948  2 snd_opl3_lib,snd_rawmidi
>snd                    49380  10
>snd_pcm_oss,snd_mixer_oss,snd_cmipci,snd_pcm,snd_opl3_lib,snd_timer,snd_hwdep,snd_mpu401_uart,snd_rawmidi,snd_seq_device
>
>
>
>(bttv module is loaded)
>
>and my lspci gves me::
>
>0000:03:09.0 Multimedia video controller: Brooktree Corporation Bt878
>Video Capture (rev 11)
>0000:03:09.1 Multimedia controller: Brooktree Corporation Bt878 Audio
>Capture (rev 11)
>
>thnx a lot for the interest. I have tryed both emerging kdetv and
>compiling from the sources but nothing works. kdetv says no devices
>found.
>
>i hope i have been complete.
>
>On 7/5/05, ghkilo <[email protected]> wrote:
>  
>
>>Hello,
>>
>>please tell the community more about your tv-card, because many
>>tvv-cards with an BT8x8 Chip are around teh world.
>>
>>Tuner:
>>BT/CX: BT878
>>Mnaufacturer:
>>
>>Not more is needed to help you.
>>
>>best regards gerhard
>>
>>    
>>
>_______________________________________________
>kwintv mailing list
>[email protected]
>https://mail.kde.org/mailman/listinfo/kwintv
>
>  
>
Thanks,

it seems no recognition by missing V4L or V4L2 modules.
Kdetv needs one of them, libzvbi also for Videotextplugin enabled.

The V4L drivers should installed an loaded in "X11Conf, or XF86Config-4"

happy installing

Gerhard