Re: how to use Konqueror behind a firewall
Will Andrews <[email protected]>
| Newsgroups | gmane.comp.kde.non-linux |
|---|---|
| Message-ID | <[email protected]> |
On Sun, May 26, 2002 at 07:06:38PM +1000, Ivan Carey wrote: > How do I use Konqueror behind a firewall? > I do not have a proxy server installed. > My network consists of a FreeBSD box a Windows 2000 box and a FreeBSD firewall connected to the internet via dialup. > I can get the Windows 2000 box to use the firewall by telling the network setup to use the firewall as a gateway. > The only way to use Konqueror that I can see is via a proxy server. It sounds like you have set up your FreeBSD firewall to act as a NAT/PAT gateway. If so, all you need to do is make sure your FreeBSD box sets its default gateway to your firewall's IP. Nothing special needed in Konqueror. Regards, -- wca