Help needed on Solaris 10 Zones

Hi,



I have an application that runs only one instance on a machine, hence
the need for zones, to run multiple instances.

The question I have is how I can know if a process is running on the
non-global zone.

Is there a command that can be used on global-zone to see if a process
is running on global or non-global zone?



Thanks in Advance

Saurabh



**************** CAUTION - Disclaimer *****************
This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended solely for the use of the addressee(s). If you are not the intended recipient, please notify the sender by e-mail and delete the original message. Further, you are not to copy, disclose, or distribute this e-mail or its contents to any other person and any such actions are unlawful. This e-mail may contain viruses. Infosys has taken every reasonable precaution to minimize this risk, but is not liable for any damage you may sustain as a result of any virus in this e-mail. You should carry out your own virus checks before opening the e-mail or attachment. Infosys reserves the right to monitor and review the content of all messages sent to or from this e-mail address. Messages sent to or from this e-mail address may be stored on the Infosys e-mail system.
***INFOSYS******** End of Disclaimer ********INFOSYS***

___________________________________________________
This message is from the kde-solaris mailing list.
Account management:  https://mail.kde.org/mailman/listinfo/kde-solaris.
Archives: http://lists.kde.org/.
More info: http://www.kde.org/faq.html.