Re: Problem with KDE PIM under SLED 11

Hi Uwe,

Greetings to the RWTH from a former RWTH'ler. :-)


On Friday 22 May 2009, Uwe Werner wrote:
> Hello,
>
> I am searching for a solution. Here is the Problem:
> I am using Kontact under SLED 11. Since a few days i'm unable to send
> E-Mails. E-Mail receiving is possible. I get always a fault
> "Versandweg RWTH ungueltig"   translated something like "sendway
> invalid". This configured sendway "RWTH" isnt configured yet. It is
> an older configuration for the snmp in K-Mail which i've deleted. In
> case these config was wrong.
> But Kmail is using it yet. I was not able to change these config in
> the GUI. I've deleted it and the GUI don't shows it anymore but Kmail
> uses it. I have to complement that i've copied other Maildata from
> KDE 3.x.x from Opensuse 10.3 to the /home/%user%/.kde4 folder.
> Afterwords it works fine. Than i've made some changes which i'm not
> remember at all. One thing was the deletion of these "RWTH"
> configuration. The result is this situation.

Did you check your identity configuration? Maybe it still refers to the 
deleted "RWTH" configuration (on the Advanced tab under "Special 
transport").

Does sending a message work if you explicitly choose a working sending 
account (via Message->Send Mail Via->...)?


Regards,
Ingo

_______________________________________________
KDE PIM users mailing list
[email protected]
https://mail.kde.org/mailman/listinfo/kdepim-users

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v2.0.9 (GNU/Linux)

iEYEABECAAYFAkoW+9YACgkQGnR+RTDgudgumACgq+PFwEYXXn4rv7UPCF6++SyX
J8kAnRDkcGaedhCuWOaPDCheFGrV2idh
=A8ed
-----END PGP SIGNATURE-----