Re: ssh tunneling with Kontact?

[ Comments below, in line ]

On Sunday 25 October 2009 at 7:09 pm, r bartlett penned
about "Re: [kdepim-users] ssh tunneling with Kontact?"

> If you were going to set this up with xclock, what would you type at
> the command line?  I assume I could substitute xclock for kontact
> and be all set.  For one computer, the command is simply: 
> 
> ssh -X computer1 kontact

Hi,

Suppose I'm on `computer-a' and want to see `computer-c' via
`computer-b', here's what I do:

   computer-a$ ssh -Y computer-b
   computer-b$ ssh -Y computer-c
   computer-c$ xclock

;)

Of course it assumes X-forwarding is enabled on `computer-b' and
`computer-c'

Cheers,
-- 
Pablo Sanchez - Blueoak Database Engineering, Inc
Ph:    819.459.1926      Fax:   760.860.5225 (US)