Re: akregator uses 100% cpu with akonadi upgrade

On Thursday, October 10, 2013 11:01:12 AM Daniel Vrátil wrote:
> On Thursday 10 of October 2013 09:38:57 Shridhar Daithankar wrote:
> > Hi all,
> 
> Hi,
> 
> > On arch linux, a recent update pulled in akonadi 1.10.3 and with that,
> > akregator(4.11.2) has started consuming 100% CPU and is totally
> > unresponsive.
> 
> Akregator is not using Akonadi, so the update is most probably irrelevant.
> 
> > Its something about the feeds. If I remove the feeds and start with the
> > vanilla one, it works fine. But importing the feeds reverts it to the same
> > unresponsive state.
> > 
> > Since my I track quite a few feeds(about 100 or so), its quite impossible
> > to bisect the problem further.
> > 
> > Has anybody else seen this? googling isn't turning up anything.
> > 
> > Should I file a bug for the same?
> 
> Please open a new bug report. Also start akregator from console and see
> whether it prints any errors or warnings (make sure "akregator" is enabled
> in kdebugdialog) and if so, attach them to the report.

done. https://bugs.kde.org/show_bug.cgi?id=325847

Thanks

-- 
Regards
 Shridhar
_______________________________________________
KDE PIM users mailing list
Subscription management: https://mail.kde.org/mailman/listinfo/kdepim-users