*DTAQ existence API
Kelly Beard <[email protected]>
| Newsgroups | gmane.comp.lang.as400.c |
|---|---|
| Message-ID | <CAOvM2Sv0sWDVJ5peVQSYWwg+=hz5S0ve8-Xej+0LQ5MwpyLPTw@mail.gmail.com> |
http://www.ibm.com/support/knowledgecenter/en/ssw_ibm_i_71/apis/qmhqrdqd.htm QMHQRDQD() is an API without an error receiver variable, yet the page lists possible error codes. How do you get these back from the API? I need a good C/C++ example on this. Also, isn't there a reason no CRTDTAQ API is available? Why just a command? That makes it difficult to capture any potential errors on that as well. -- Kelly Beard -- This is the Bare Metal Programming IBM i (AS/400 and iSeries) (C400-L) mailing list To post a message email: C400-L-Zwy7GipZuJhWk0Htik3J/[email protected] To subscribe, unsubscribe, or change list options, visit: http://lists.midrange.com/mailman/listinfo/c400-l or email: C400-L-request-Zwy7GipZuJhWk0Htik3J/[email protected] Before posting, please take a moment to review the archives at http://archive.midrange.com/c400-l.