Re: Can i use QLIMROIR to determine if a dataarea is being used by a program
Dave McKenzie <[email protected]>
| Newsgroups | gmane.comp.lang.as400.mi |
|---|---|
| Message-ID | <[email protected]> |
You could use QLIMROIR, but it would be much simpler to use the DSPPGMREF command to an outfile, then read the outfile. Then your program wouldn't have to be system state. --Dave Krish Thirumalai wrote: > http://archive.midrange.com/mi400/200402/msg00007.html > > I came across this example in the archives of using the QLIMROIR to > change the program attribute. Could this MI program be used to > determine if a specific data area is being used by a program. Could > someone provide an example of how you would do this if it is possible > ? > > We have a requirement that we want to determine if a program is using > a data area and want to do it at run time > > Thanks > > -- > Krish Thirumalai _______________________________________________ This is the MI Programming on the AS400 / iSeries (MI400) mailing list To post a message email: MI400-Zwy7GipZuJhWk0Htik3J/[email protected] To subscribe, unsubscribe, or change list options, visit: http://lists.midrange.com/mailman/listinfo/mi400 or email: MI400-request-Zwy7GipZuJhWk0Htik3J/[email protected] Before posting, please take a moment to review the archives at http://archive.midrange.com/mi400.