Re: Accessing objects in another job's QTEMP
"Walden H. Leverich" <WaldenL-z/[email protected]>
| Newsgroups | gmane.comp.lang.as400.mi |
|---|---|
| Message-ID | <[email protected]> |
>Such a command would also seem to have to modify the QTEMP address located in the PCO of the initial job. Yup. That's how it would work. >you should most likely review my posts to this forum of: Yup. That's what I was wondering, so it would be effected by those changes. OK. Thanks. -Walden ------------ Walden H Leverich III Tech Software (516) 627-3800 x3051 [email protected] http://www.TechSoftInc.com Quiquid latine dictum sit altum viditur. (Whatever is said in Latin seems profound.) _______________________________________________ This is the MI Programming on the AS400 / iSeries (MI400) mailing list To post a message email: MI400-Zwy7GipZuJhWk0Htik3J/[email protected] To subscribe, unsubscribe, or change list options, visit: http://lists.midrange.com/mailman/listinfo/mi400 or email: MI400-request-Zwy7GipZuJhWk0Htik3J/[email protected] Before posting, please take a moment to review the archives at http://archive.midrange.com/mi400.