Re: Accessing objects in another job's QTEMP

Rory,

In the V5R4 Memo to Users there is a section titled Changes to Trace 
commands.  The first paragraph is:

In V5R4, the Trace Job (TRCJOB) command was changed to run the Start Trace 
(STRTRC), End Trace (ENDTRC), and Print Trace (PRTTRC) CL commands that 
were added to the operating system in V5R1. Because there is no equivalent 
function on the STRTRC command, the Program to call before trace (EXITPGM) 
and Select procedures to trace (SLTPRC) parameters are not supported. Any 
values specified for these parameters are ignored. You might need to 
change any CL programs that used the TRCJOB command and specified the 
EXITPGM or SLTPRC parameters.

Bruce Vining




Rory Hewitt <[email protected]> 
Sent by: mi400-bounces-Zwy7GipZuJhWk0Htik3J/[email protected]
02/15/2006 03:57 PM
Please respond to
MI Programming on the AS400 / iSeries <mi400-Zwy7GipZuJhWk0Htik3J/[email protected]>


To
mi400-Zwy7GipZuJhWk0Htik3J/[email protected]
cc

Subject
[MI400] Accessing objects in another job's QTEMP






Bruce Vining wrote:

>QWCJBITP will certainly be a significant aid when trying to debug a users
>job, fix up some problem in a file of another users job, etc.  An
>advantage when using this API over previous approaches (such as break
>handling programs) is that there is, in general, no need to have some 
form
>of setup run in the "other" job (like allocating a *MSGQ).

Bruce,

Of course if you use the STRSRVJOB + TRCJOB with an exit program, there's 
no
setup requirement in the target job either. There is some overhead with 
the
servicing stuff, but it's pretty minimal. I use my version of this to get
the QTEMP objects of batch server jobs on a daily basis. If anyone else
wants the code, send me an email offline (rory dot hewitt at gmail dot 
com)

Rory
_______________________________________________
This is the MI Programming on the AS400 / iSeries (MI400) mailing list
To post a message email: MI400-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/mi400
or email: MI400-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/mi400.


_______________________________________________
This is the MI Programming on the AS400 / iSeries (MI400) mailing list
To post a message email: MI400-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/mi400
or email: MI400-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/mi400.