Re: setsppfp crashes with MCH6801
Thomas Raddatz <[email protected]>
| Newsgroups | gmane.comp.lang.as400.mi |
|---|---|
| Message-ID | <[email protected]> |
Thanks a lot for your detailed information. QSECURITY shows 30. But probably you are right that it was changed back from a higher level without any IPL. I will check that tomorrow and let you know about it. > Your technique will not work at higher security levels. You should find > an alternative method. The DSPBNDDIR command supports *OUTFILE. You'd > be better off using that. *OUTFILE is too slow because I have to randomly check for and manage specific entries. Thomas Raddatz. Simon Coulter schrieb: > On 07/05/2006, at 3:34 AM, Thomas Raddatz wrote: > >> I have a program that utilizes setsppfp() to get a pointer to the >> associated space of a binding >> directory object. It runs fine on our development box as well as on >> our production box. The program >> crashes with MCH6801 on our test box which is another LPAR of our >> production box. The violation type >> is 1 = Object domain violation. >> >> Both LPARS (production and test) are at security level 30. As far as I >> know the production LPAR is >> DBCS and the test LPAR is SBCS. Both LPARs are at PTF level TL05298. > > I presume the LPARs are on the same version of OS/400? > > The MCH6801 indicates the failing partition is NOT running at security > level 30. > > Are you positive the security level on the failing LPAR is 30? The > QSECURITY system value may show 30 but it may have been changed. If it > was originally at a higher level that will still be in effect unless > the partition has been IPLed after it was changed. Perhaps you should > arrange for the partition to be IPLed just to be sure. > > Your technique will not work at higher security levels. You should find > an alternative method. The DSPBNDDIR command supports *OUTFILE. You'd > be better off using that. > > > Regards, > Simon Coulter. > -------------------------------------------------------------------- > FlyByNight Software AS/400 Technical Specialists > > http://www.flybynight.com.au/ > Phone: +61 3 9419 0175 Mobile: +61 0411 091 400 /"\ > Fax: +61 3 9419 0175 \ / > X > ASCII Ribbon campaign against HTML E-Mail / \ > -------------------------------------------------------------------- > > > _______________________________________________ > This is the MI Programming on the AS400 / iSeries (MI400) mailing list > To post a message email: MI400-Zwy7GipZuJhWk0Htik3J/[email protected] > To subscribe, unsubscribe, or change list options, > visit: http://lists.midrange.com/mailman/listinfo/mi400 > or email: MI400-request-Zwy7GipZuJhWk0Htik3J/[email protected] > Before posting, please take a moment to review the archives > at http://archive.midrange.com/mi400. > > _______________________________________________ This is the MI Programming on the AS400 / iSeries (MI400) mailing list To post a message email: MI400-Zwy7GipZuJhWk0Htik3J/[email protected] To subscribe, unsubscribe, or change list options, visit: http://lists.midrange.com/mailman/listinfo/mi400 or email: MI400-request-Zwy7GipZuJhWk0Htik3J/[email protected] Before posting, please take a moment to review the archives at http://archive.midrange.com/mi400.