Re: How to call MATAGPAT and MATHSAT for another job

If you're already familiar with those instructions and your interest is in the initial thread of another job, then you might want to look at the Call Job Interrupt Program API QWCJBITP documented at http://publib.boulder.ibm.com/infocenter/iseries/v5r4/topic/apis/qwcjbitp.htm
   
  Bruce Vining
  http://www.brucevining.com/
  Your System i tools provider

Thomas Raddatz <[email protected]> wrote:
  Hi,

Does someone know if it is possible to call MATAGPAT and MATHSAT for another job? So far I use 
QWVOLAGP to get a list of activation groups. But I do not know how to call MATAGPAT and MATHSAT to get 
further information about memory utilization. Both procedures do not have a "job" parameter.

Regards,

Thomas.
_______________________________________________
This is the MI Programming on the AS400 / iSeries (MI400) mailing list
To post a message email: MI400-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/mi400
or email: MI400-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/mi400.




Bruce
Bruce Vining Services
507-206-4178
_______________________________________________
This is the MI Programming on the AS400 / iSeries (MI400) mailing list
To post a message email: MI400-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/mi400
or email: MI400-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/mi400.