Re: MI program unable to locate job - need assistance

By the way, does anyone know if IBM *has* increased the number of Work 
Control Block tables from thirty?  That could explain the problem.

IBM?


----- Original Message ----- 
From: "James Lampert" <jamesl-6/ELSmrcqeUu8xhjR5IN5AC/[email protected]>
To: "MI Programming on the AS400 / iSeries" <mi400-Zwy7GipZuJhWk0Htik3J/[email protected]>
Sent: Tuesday, May 13, 2008 1:40 PM
Subject: Re: [MI400] MI program unable to locate job - need assistance


> Paul Jackson wrote:
>> Hi Richard,
>>
>> this was code that I obtained from Tim McCarthy when he was at 
>> Trailblazer
>> systems ca. 1996.  I've never debugged an MI program before.  Any tips on
>> how to do this?
>
> To begin with, you need a compilation listing. Debugging is through the
> OPM debugger, by hexadecimal instruction number; all variables can be
> accessed through DSPPGMVAR unless their names start with periods.
>
> When setting breakpoints, use the instruction number (I don't have a
> compilation listing in front of me, but I believe it's the second
> column, the one that shows an ascending sequence of hexadecimal
> numbers). For example, if the instruction of interest is at instruction
> number 002D, then you would set your breakpoint at '/002D' (including
> the slash and the single quotes, to tell the debugger that you want an
> instruction number rather than a HLL statement number).
>
> -- 
> James H. H. Lampert
> Touchtone Corporation
>
> _______________________________________________
> This is the MI Programming on the AS400 / iSeries (MI400) mailing list
> To post a message email: MI400-Zwy7GipZuJhWk0Htik3J/[email protected]
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/mi400
> or email: MI400-request-Zwy7GipZuJhWk0Htik3J/[email protected]
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/mi400.
>
> 

_______________________________________________
This is the MI Programming on the AS400 / iSeries (MI400) mailing list
To post a message email: MI400-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/mi400
or email: MI400-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/mi400.