Re: MI program unable to locate job - need assistance

Hi Simon,

how do set up the debuggable identifiers?  Also I couldn't figure out
how to display the value of a pointer (at least using dsppgmvar)

Thanks!

On Sat, May 17, 2008 at 1:03 AM, Simon Coulter <shc-Q/[email protected]> wrote:
>
> On 16/05/2008, at 9:04 AM, Paul Jackson wrote:
>
>> Sorry, I was a bit premature with that statement.  The pointers are at
>> the normal position but for some reason it seems as if the SETSPPFP
>>  .WCBSPC, .WCB-TABLES(THE-TABLE);  statement is not setting .WCBSPC
>> properly as the based on structure is all hex zeros.
>
> That's very odd. Can you recompile it with debuggable identifiers and
> determine what .WCBSPC is set to before and after the SETSPPFP
> operation?
>
> You said you were running this on VRM540, QSECURITY=40, and program
> set to system-state. I compiled on 510, set system state (including
> proper checksums) and tried it and it worked. I then saved the
> program and test program, restored on VRM540, and tried it, and it
> worked,
>
> So the code seems fine--although it's not the most efficient way of
> locating a given job.
>
> I wonder what else is different on the failing system? Same level of
> LIC? Same Cume level?
>
> Regards,
> Simon Coulter.
> --------------------------------------------------------------------
>    FlyByNight Software         OS/400, i5/OS Technical Specialists
>
>    http://www.flybynight.com.au/
>    Phone: +61 2 6657 8251   Mobile: +61 0411 091 400        /"\
>    Fax:   +61 2 6657 8251                                   \ /
>                                                              X
>                  ASCII Ribbon campaign against HTML E-Mail  / \
> --------------------------------------------------------------------
>
>
>
> _______________________________________________
> This is the MI Programming on the AS400 / iSeries (MI400) mailing list
> To post a message email: MI400-Zwy7GipZuJhWk0Htik3J/[email protected]
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/mi400
> or email: MI400-request-Zwy7GipZuJhWk0Htik3J/[email protected]
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/mi400.
>
>
_______________________________________________
This is the MI Programming on the AS400 / iSeries (MI400) mailing list
To post a message email: MI400-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/mi400
or email: MI400-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/mi400.