Re: Using precompiled base library

[email protected] wrote:
> Hi All,
> 
> Any suggestions how I could use a precompiled base library?

It was possible to do so when ISE was still using Ace natively.
No effort has been made to make it work with ECF. I looked at some
existing ECF files and I'm not sure I understand how it works.
Do we have to specify both lines below:

<precompile name="precompile" location="$ISE_PRECOMP\base.ecf"/>
<library name="base" location="$ISE_LIBRARY\library\base\base.ecf"/>

> I usually have this:
> 
> 	<mount location="${GOBO}/library/kernel.xace"/>
> 
> That can be replaced by
> 
>   <precompiled .../>
> 
> ? To what does precompiled point?
> 
> And most importantly, does this save compilation time?

Some people say so. Personally I stopped using them a long
time ago.

-- 
Eric Bezault
mailto:ericb-D6Qt/9opevxWk0Htik3J/[email protected]
http://www.gobosoft.com


------------------------------------

To Post a message, send it to:   [email protected]
To Unsubscribe, send a blank message to: [email protected]! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/gobo-eiffel/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/gobo-eiffel/join
    (Yahoo! ID required)

<*> To change settings via email:
    [email protected] 
    [email protected]

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/