Re: Segfault by purging native and reloading beam
Richard Carlsson <[email protected]> Fri, 15 May 2015 15:32:25 +0200
| Newsgroups | gmane.comp.lang.erlang.bugs |
|---|---|
| Message-ID | <CANKG3zkK=xxRSAESjFwpsRhpzvPLDM-CYdaTqUKG_Y-T-Egg8w@mail.gmail.com> |
cc:ing list. On Fri, May 15, 2015 at 3:19 PM, Jeremy Heater < [email protected]> wrote: > A useful observation maybe: in R16B01 it also always segfaults, and from > R16B02 onwards there is the behavior where it only segfaults from time to > time (it also happens in 17.1 and 17.4, what I had on hand to test). > > 2015-05-15 14:18 GMT+02:00 Richard Carlsson <[email protected]>: > >> This one was a bit tricky to minimize: you have to load beam code, then >> remove it fully, then load native, remove it fully again, then reload the >> beam code. Repeatable every time on plain old R15B03-1 and about one in >> three times on 18.0. See example module. >> >> /Richard >> >> _______________________________________________ >> erlang-bugs mailing list >> [email protected] >> http://erlang.org/mailman/listinfo/erlang-bugs >> >> > _______________________________________________ erlang-bugs mailing list [email protected] http://erlang.org/mailman/listinfo/erlang-bugs