Re: Question about connecting to a node and proposed patch

Hi Matthias,

Matthias Radestock <[email protected]> writes:
> Bill Clementson <[email protected]> writes:
>
>> Matthias Radestock <[email protected]> writes:
>>> So, to connect and reconnect just run 'M-x erl-ping'. To switch nodes
>>> (and connect) run 'C-u M-x erl-ping'.
>>
>> Works for me. 
>
> Find attached a suitable patch. I've made the presence of a prefix arg a
> general trigger for all commands that accept a node.
>
>>> Any suggestions for a key-binding? 'C-c C-d @' or 'C-c C-d !' perhaps?
>>
>> "C-c C-d @" seems appropriate.
>
> Fine by me, though both "!" and "@" are shifted on many keyboards, which
> makes them less ideal.
>
> Anyway, I leave it up to you to pick a suitable key and check-in the
> whole lot.

Sorry it's taken me a few days to get to this but it was a long
weekend here in Canada and I haven't had much computer time.

I've applied your patch, added a key binding of "C-c C-d g" for
erl-ping and updated the distel.texi documentation file (Conventions
section). All mods have now been committed.

Regards,
Bill


-------------------------------------------------------------------------
This SF.net email is sponsored by DB2 Express
Download DB2 Express C - the FREE version of DB2 express and take
control of your XML. No limits. Just data. Click to get it now.
http://sourceforge.net/powerbar/db2/