Re: distel and emacs unicode-2 (again)

> If the problem only occurs with the unicode-2 branch of CVS emacs,
> have you investigated the possibility that the node communication
> might be undergoing a unicode transformation and thus not being
> interpreted correctly in distel? You should be able to verify this
> if you:
> 
> 1. Start up emacs 23-unicode-2.
> 2. Do (setq fsm-use-debug-buffer t) so that you can trace the node
> communication.
> 3. Do the sequence of distel operations that were failing for you
> before (presumably, this was just connecting to the node "C-c C-d n"
> and trying to run some command like list processes "C-c C-d l").
> 4. Save the contents of the *fsm-debug* buffer (you might want to also
> switch to hexl mode and save the contents in that format too).
> 
Here is the content of *fsm-debug* with emacs 23:
EVENT: init - "pemacs"
SEND : "^@^Fpemacs"
STATE: epmd-process -> epmd-recv-port-resp
EVENT: data - "\204\273"
TERM : -31557
FAIL : "Error on event data in stat..." (buffer: #<buffer *reg group-leader*>)

^@^F is in red (and cannot even be copy-paste anywhere). I do know if the p in
front of emacs is supposed to be there at all.

I guess this is the problem but I have not clue what it actually means. 

Any idea ?

Thanks




-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/