Debugger broken?

Hi,

when I try to use the Distel debugger interface, it jumps right into
my face. Steps to reproduce:

  1. Select buffer with Erlang source (corresponding .beam compiled
     with debug_info).
  2. C-c C-d i
  3. Set a breakpoint with C-c C-d b
  4. Run program, breakpoint is reached, EDB Monitor pops up
  5. Select process which ran into break

Immediately afterwards, nodedown: my@node\.somewhere\.de is displayed
in the status line and *edbproc <?.132.0> on my@node\.somewhere\.de*
(Erlang EXT (attached)) in the mode line. An empty buffer is
displayed.

I tried wiping and reinstalling distel to no avail. Any hints where I
should look?

      Goodbyte, Gerd.

P.S.: The mailing list has been very quiet in the last few months. Is
      Distel just working for everybody else or not used any more?

-- 
Gerd Flaig                     Technik                [email protected]
Bei Schlund + Partner AG       Brauerstraße 48      D-76135 Karlsruhe
 Physics is like sex: sure, it may give some practical results,
 but that's not why we do it. -- Richard Feynman



-------------------------------------------------------
This SF.net email is sponsored by: IT Product Guide on ITManagersJournal
Use IT products in your business? Tell us what you think of them. Give us
Your Opinions, Get Free ThinkGeek Gift Certificates! Click to find out more
http://productguide.itmanagersjournal.com/guidepromo.tmpl