RE: Attempt to reassemble colorforth: the Mark Slicker bug

"howerd.oakford" <[email protected]>
Newsgroups gmane.comp.lang.forth.colorforth
Message-ID <[email protected]>
Hi Ray,

I'm not 100% clear about which file was where when you tried to Upload in
cfdos ;)
I think the confusion is over the use of the word "file" as in "a file I
made on disk".

The principle is : you select a Win/DOS file using F6, say play.blk.
The display will show you the filename in the bottom right of the screen.
"U" and "D" are symmetric - they transfer data between the selected file and
the raw sectors on the floppy disk.
"U" Uploads raw data from the floppy to the file play.blk.
"D" Downloads the data from the file play.blk to the floppy.
But you probably know this already!

I presume that the floppy disk contained data from a file other than
cf800.blk, otherwise you would not notice any difference after you Uploaded
it ...
The only other explanation is that the floppy had read errors - I think I
report these, but its hard to test.

I checked out the cfdos4 "U" function on my PC - seems to work fine...

Good luck with the search for a suitable PC!
Try to avoid corporate PCs like Dell and Compaq - they are a law unto
themselves and tend not to support VESA or sensible hardware...
BTW I have yet to find a _laptop_ that doesn't run colorForth.

Regards

Howerd

-----Original Message-----
From: Ray St. Marie [mailto:[email protected]]
Sent: 24 May 2005 01:58
To: [email protected]
Subject: Re: [colorforth] Attempt to reassemble colorforth: the Mark
Slicker bug
Howerd, I just wanted to report that...
while using cfdos4 to try to view a file I made on disk, the file will
not upload using `U'.
I copied file cf800.blk, called it play.blk, and tryed to upload 256
blocks to the selected play.blk file.

The light came on the floppy, I assume it was read, but the file did
not get written and the display  continued to show cf800.blk code in
my uploaded play.blk.

Thought you should know,

Ray

ps.
I'm using the cfdos to help me make several disks that I will use to
find the perfect machine :)
Wish me luck.

--
Ray St. Marie
Rastm2ATusersDOTsourceforgeDOTnet
Ray.StMarieATgmailDOTcom and ATsbcglobalDOTnet
Ray_stmarieAThotmailDOTcom
Raystm2 and rastm2 in Internet Relay Chat (irc)
/connect  irc.freenode.net Busness discussion: /join #biz
ColorForth: /join #c4th #c4th-ot Forth: /join #retro #forth #concatenative
Programming: /join #python #lisp #scheme #asm

---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Main web page - http://www.colorforth.com
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.