Re: Oasis compilation of a single section among several

Salut
J'avais pas teste mais ça ne marche pas. :)

C'est un peu dodu comme code en fait. Y'a pas loin de 750 fichiers.
J'avais vu ton mail a propos d'obuild, mais j'ai pas pris le temps
d'essayer de l'utiliser. Même si a l'air plus rapide qu'ocamlbuild. :/

a+
Johan


2014-02-17 15:17 GMT+09:00 Francois Berenger <[email protected]>:

> On 02/17/2014 03:02 PM, Johan Mazel wrote:
> > Hi
> > I have an Oasis project with two executables.
> > However the compilation is quite long (around 5 minutes) and most of the
> > time, I only want to compile a single executable (not both).
> > Is there any mechanisms in Oasis that would allow me to do this?
>
> A stupid and dirty workaround during development: comment out
> the section of the _oasis file you don't want to compile.
>
> > Thanks for your time.
> >
> > Regards.
> > Johan Mazel
> >
> >
>
>
> --
> Best regards,
> Francois Berenger.
>
>
> ------------------------------------
>
> Archives up to December 31, 2011 are also downloadable at
> http://www.connettivo.net/cntprojects/ocaml_beginners
> The archives of the very official ocaml list (the seniors' one) can be
> found at http://caml.inria.fr
> Attachments are banned and you're asked to be polite, avoid flames
> etc.Yahoo Groups Links
>
>
>
>