Please test DBI-1.628_50 re change in PrintWarn

The PrintWarn attribute used to default to the same value as $^W.
In other words, if you ran perl with -w then would be on.

See https://metacpan.org/module/TIMB/DBI-1.627/DBI.pm#PrintWarn

That was reasonable back in early 2004 when PrintWarn was added to the
DBI.  I'm planning to change PrintWarn to always default on.

There's a small risk that this change will cause extra warnings to be
logged from your application if it's doing something that triggers the
driver to record warning states (via the set_err method).

I've uploaded DBI-1.628_50 as a trial release of DBI-1.629 so you can
test it *with your application code* (not just make test) and report back.

Please report back whether you have extra warnings logged *OR NOT*
and don't forget to mention what driver you're using.

Thanks!

Tim.

p.s. DBI-1.628_50 will install as $DBI::VERSION 1.629.
Changes: https://metacpan.org/changes/release/TIMB/DBI-1.628_50#Changes-in-DBI-1.629