Re: DBI doesn't seem to build on install?
"H.Merijn Brand" <[email protected]>
| Newsgroups | gmane.comp.lang.perl.modules.dbi.sybase.devel |
|---|---|
| Message-ID | <[email protected]> |
On Sun, 5 Jul 2009 16:49:29 +0000, Steven McGowan <[email protected]> wrote: > Looks good > > I see you're using perl 5.008008 on darwin-thread-multi-2level, okay. > Remember to actually *read* the README file! > Use 'make' to build the software (dmake or nmake on Windows). > Then 'make test' to execute self tests. > Then 'make install' to install the DBI and then delete this working > directory before unpacking and building any DBD::* drivers. > > Writing Makefile for DBI > -- NOT OK So, you are unable to write a Makefile. All bets are off after this point. Before you clean up the mess it left, try some manual intervention $ cd ~/.cpan/build/DBI* $ perl Makefile.PL and see if that tells you *why* it cannot create a Makefile > Running make test > Can't test without successful make > Running make install > make had returned bad status, install seems impossible -- H.Merijn Brand http://tux.nl Perl Monger http://amsterdam.pm.org/ using & porting perl 5.6.2, 5.8.x, 5.10.x, 5.11.x on HP-UX 10.20, 11.00, 11.11, 11.23, and 11.31, OpenSuSE 10.3, 11.0, and 11.1, AIX 5.2 and 5.3. http://mirrors.develooper.com/hpux/ http://www.test-smoke.org/ http://qa.perl.org http://www.goldmark.org/jeff/stupid-disclaimers/