(unknown)

Hello,

I'm having problems getting the current DBD::Sybase 1.07 to
install on a Solaris 8 system (via CPAN).  The particulars:

     - Perl built on Solaris 7 (first with 5.6.1, now with 5.8.7)
     - "make install" run on Solaris 8
     - Installed newer CPAN (with all pre-reqs) and then DBI (1.48)
       via CPAN as well
     - Sybase/$SYBASE is in /usr/local/sybase; using Sybase 12.5.1

When I go to install DBD::Sybase, it builds OK and then gets
to the tests, and that's where I hit this:

[...]
Running make test
PERL_DL_NONLAZY=1 /usr/bin/perl "-MExtUtils::Command::MM" "-e"  
"test_harness(0, 'blib/lib', 'blib/arch')" t/*.t
t/autocommit....ok
t/base..........ok
t/exec..........NOK 11
#     Failed test (t/exec.t at line 88)
t/exec..........ok 12/22# Looks like you failed 1 test of 22.
t/exec..........dubious
[...]

Ran it manually, and I get the same thing (not surprisingly)

solaris8:1:273 [/.cpan/build/DBD-Sybase-1.07] # perl t/exec.t
1..22
ok 1 - use DBI;
ok 2 - use DBD::Sybase;
ok 3 - Connect
ok 4 - Prepare sp_helpindex
ok 5 - exec sysusers
ok 6 - -1 (create proc)
#
ok 7 - prepare dbitest
ok 8 - execute dbitest 1
ok 9 - exec dbitest 2
ok 10 - exec dbitest 3
not ok 11 - out param 1
#     Failed test (t/exec.t at line 88)
[... other tests OK ...]

This happens with both Perl 5.6.1 and 5.8.7, same exact thing.

I thought at first perhaps my Sybase server/login/password/database
information was incorrect, but I don't think I would've gotten this
far if it hadn't been.

That part of t/exec.t is

[...]
$rc = $sth->execute(undef, 25, 3.2234, "jan 3 2001", 5.4);
ok(defined($rc), "exec dbitest 3");
my @out = $sth->func('syb_output_params');
ok($out[0] == 5.4, "out param 1");

Neither my Perl nor my (non-existent) Sybase knowledge are good
enough to tell what's going on here.  Any ideas, Mike?

Thanks,

     - Greg