Re: Multiple Toolbars

Got it. Here's the new code (with a bit of help from wxGlade):

     $this->{toolbar2}
         = Wx::ToolBar->new( $this, -1, wxDefaultPosition, wxDefaultSize,
         wxNO_BORDER | wxHORIZONTAL | wxTB_FLAT, $ID_TOOLBAR2 );
     $this->SetToolBar( $this->{toolbar2} );
     my $toolbar2 = $this->{toolbar2};
     $toolbar2->AddTool(
         $ID_DRAW_SPECTRUM,
         "draw",
         Wx::Bitmap->new( $ProgramPath . "spectrum.png", 
wxBITMAP_TYPE_PNG ),
         wxNullBitmap,
         wxITEM_NORMAL,
         "draw spectrum"
.

.

.

     $this->{toolbar1}
         = Wx::ToolBar->new( $this, -1, wxDefaultPosition, wxDefaultSize,
         wxNO_BORDER | wxHORIZONTAL | wxTB_FLAT, $ID_TOOLBAR1 );
     $this->SetToolBar( $this->{toolbar1} );
     my $toolbar1 = $this->{toolbar1};
     $toolbar1->AddTool( $ID_QUIT, "exit",
         Wx::Bitmap->new( $ProgramPath . "exit.png", wxBITMAP_TYPE_PNG ),
         wxNullBitmap, wxITEM_NORMAL, "exit" );
.

.

.

     $toolbar2->Realize();
     $toolbar1->Realize();



On 11/09/2016 04:23 PM, Keith Brown wrote:
> Hi all. I'm trying to fit too many icons into one toolbar so I'd like 
> to break it up into two toobars. Here's what I've done:
>
> $this->CreateToolBar(wxNO_BORDER|wxHORIZONTAL|wxTB_FLAT, $ID_TOOLBAR1);
>  my $toolbar1 = $this->GetToolBar();
>  $toolbar1->AddTool( $ID_QUIT, "exit", 
> Wx::Bitmap->new($ProgramPath."exit.png", wxBITMAP_TYPE_PNG), 
> wxNullBitmap, wxITEM_NORMAL, "exit" );
> .
>
> .
>
> .
>
> $toolbar1->Realize();
> $this->CreateToolBar(wxNO_BORDER|wxHORIZONTAL|wxTB_FLAT, $ID_TOOLBAR2);
> my $toolbar2 = $this->GetToolBar();
> $toolbar2->AddTool( $ID_APPLY_IDENT, "apply trig", 
> Wx::Bitmap->new($ProgramPath."apptrig.png", wxBITMAP_TYPE_PNG), 
> wxNullBitmap, wxITEM_NORMAL, "apply trig\nidentities" );
> .
>
> .
>
> .
>
> $toolbar2->Realize();
> .
> .
> .
>
>
> This results in only one toolbar being displayed with all icons 
> appearing in it. How might I go about splitting them up into two?
>