Re: [Pharo-dev] Seaside REST on Pharo 50

Hi,

Seaside-REST is included in Seaside since version 3.1
ConfigurationOfSeasideREST is outdated; it works with version 3.0

Therefore, load the ‘REST’ group from ConfigurationOfSeaside3:

Metacello new
	configuration: 'Seaside3';
	version: #stable;
	load: ‘REST'

If you want to experiment with all of Seaside, load everything:

Metacello new
	configuration: 'Seaside3';
	version: #stable;
	load: ‘OneClick'

Seaside is also not tested on Pharo5 as it’s still a moving target. 
Use Pharo4 if you want to make sure it works.

regards
Johan

> On 25 Nov 2015, at 01:07, Franck Warlouzet <[email protected]> wrote:
> 
> I was using both ConfigurationOfSeaside3 and ConfigurationOfSeasideRest. Is it the wrong way ?
> 
> Franck
> 
> > To: [email protected] <mailto:[email protected]>
> > From: [email protected] <mailto:[email protected]>
> > Date: Wed, 25 Nov 2015 00:26:05 +0100
> > Subject: Re: [Pharo-dev] Seaside REST on Pharo 50
> > 
> > On 24/11/15 16:43, Franck Warlouzet wrote:
> > > We are working on Pharo 50, and we noticed that Seaside-REST is not
> > > working anymore.
> > 
> > How are you loading it?
> > 
> > (ConfigurationOfSeaside3 project version: #'release3.2') load: 
> > #('OneClick' 'REST')
> > 
> > There could be a configuration problem, or not the right combination of 
> > groups.
> > 
> > To resolve it, compare the package cache from Pharo4 vs Pharo5 after 
> > loading.
> > 
> > Stephan
> > 
> >

_______________________________________________
seaside mailing list
[email protected]
http://lists.squeakfoundation.org/cgi-bin/mailman/listinfo/seaside