R: R: Installing Seaside into Squak 5.2 (64 bit)

Thank you Pierce,

when I use the canonical instruction I receive 'Could not resolve: Base line of Metacello'.
As far as you know does exist an updated version of Squeak 5.2 (64 bit)?
Maybe I am using an old release.

Thank you for your help.

Lorenzo

 

-----Messaggio originale-----
Da: seaside [mailto:[email protected]] Per conto di Pierce Ng
Inviato: lunedì 15 luglio 2019 01:08
A: Seaside - general discussion
Oggetto: Re: [Seaside] R: Installing Seaside into Squak 5.2 (64 bit)

On Sun, Jul 14, 2019 at 08:20:27PM +0000, Georg Heeg wrote:
> for me GH stands for Georg Heeg, that's obvious. But in this case, I
> am not guilty. Google told me that possibly
> https://raw.githubusercontent.com/squeak-smalltalk/squeak-app/squeak-trunk/release-notes/5.2
> could the source mentioned by Pierce.

:-)

Hi Lorenzo,

I should've been clearer. GH means Github. The canonical source repo for
Seaside is https://github.com/SeasideSt/Seaside. According to the
README, for Squeak >= 5.2:

  Installer ensureRecentMetacello.
  Metacello new
    baseline: 'Seaside3';
    repository: 'github://SeasideSt/Seaside:master/repository';
    load.

Pierce

_______________________________________________
seaside mailing list
[email protected]
http://lists.squeakfoundation.org/cgi-bin/mailman/listinfo/seaside

_______________________________________________
seaside mailing list
[email protected]
http://lists.squeakfoundation.org/cgi-bin/mailman/listinfo/seaside