R: R: R: Installing Seaside into Squak 5.2 (64 bit)
"Lorenzo Schiavina" <[email protected]>
| Newsgroups | gmane.comp.lang.smalltalk.squeak.seaside |
|---|---|
| Message-ID | <[email protected]> |
Hi Pierce! Grazie mille!!!!!!!!!!!!!!!! I got it!!!! Can you tell me where you got 'Installer ensureRecentMetacello'? I think it was the key step. Grazie Lorenzo -----Messaggio originale----- Da: seaside [mailto:[email protected]] Per conto di Pierce Ng Inviato: martedì 16 luglio 2019 02:15 A: Seaside - general discussion Oggetto: Re: [Seaside] R: R: Installing Seaside into Squak 5.2 (64 bit) On Mon, Jul 15, 2019 at 11:40:13AM +0200, Lorenzo Schiavina wrote: > when I use the canonical instruction I receive 'Could not resolve: Base line of Metacello'. Did you "Installer ensureRecentMetacello"? I just did the following in a fresh 64-bit Squeak 5.2 image. The Seaside control panel UI looks funny but at least one button works even though it doesn't look like a button. And Seaside runs. > Installer ensureRecentMetacello. > Metacello new > baseline: 'Seaside3'; > repository: 'github://SeasideSt/Seaside:master/repository'; > load. Pierce _______________________________________________ seaside mailing list [email protected] http://lists.squeakfoundation.org/cgi-bin/mailman/listinfo/seaside _______________________________________________ seaside mailing list [email protected] http://lists.squeakfoundation.org/cgi-bin/mailman/listinfo/seaside