Re: for ML version 110.55

The new command is, for example:
Control.Print.printDepth := 100;

Vesa

On Fri, 14 Oct 2005, Muhibba Haque wrote:

> What's the command to increase the nesting level in ML
> 110.55 version? Earlier for ML 110.0.7 version, I used
> to use this command:
> Compiler.Control.Print.printDepth := 50;
>
> But for ML 110.55 version, this doesn't work. Can you
> suggest.
>
> Thanks,
>
> Liz
>
>
>
>
>
> __________________________________
> Yahoo! Music Unlimited
> Access over 1 million songs. Try it free.
> http://music.yahoo.com/unlimited/
>
>
> -------------------------------------------------------
> This SF.Net email is sponsored by:
> Power Architecture Resource Center: Free content, downloads, discussions,
> and more. http://solutions.newsforge.com/ibmarch.tmpl
> _______________________________________________
> Smlnj-list mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/smlnj-list
>

-- 
                                     /`---*\
                                    = ^ o ^ =
                                     `-----'


-------------------------------------------------------
This SF.Net email is sponsored by:
Power Architecture Resource Center: Free content, downloads, discussions,
and more. http://solutions.newsforge.com/ibmarch.tmpl